33 55 041 Replacing anti-roll bar link for anti-roll bar on left or right

WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle

IMPORTANT: Do not mix up anti-roll bar links

Stabilizer link for active stabilizer
Anti-roll bar link for conventional anti-roll bar

Fig 1: Identifying Stabilizer And Anti-Roll Bar Link

Courtesy of BMW OF NORTH AMERICA, INC.

Vehicle with ARS

Unscrew nuts (1).

Remove anti-roll bar link (2).

Tightening torque 33 55 2AZ .

Installation note:

Replace self-locking nuts.

Fig 2: Identifying Anti-Roll Bar Link And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Vehicle without ARS

Slacken nut (1).

Tightening torque 33 55 2AZ.

Release nut (2) and remove anti-roll bar link (3).

Tightening torque 33 55 2AZ.

Installation note:

Replace self-locking nuts.

Fig 3: Identifying Anti-Roll Bar Link And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.