65 50 160 Removing and installing/replacing trim for rear cabin monitor display at front and rear

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 340

Important!

Trims may only be replaced in pairs so as to avoid differences in color.

Unclamp trims (1) on both sides with special tool 00 9 340 .

Installation note:

Make sure trims (1) are securely seated in rear cabin monitor trim at front.

Fig 1: Disconnecting Trims Using Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 65 52 2AZ .

Fig 2: Identifying Rear Monitor Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclamp trim for display at rear (1) with special tool 00 9 340 and remove

Fig 3: Removing Rear Panel Display Using Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Carefully remove trim for display at front (2) and disconnect plug connection (3).

Installation note:

Make sure ribbon cable is securely seated.

Fig 4: Identifying Front Panel Display Screws

Courtesy of BMW OF NORTH AMERICA, INC.