54 10 030 Remove and install mechanism for the rear glass slide/tilt sunroof cover: Notes

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Also comply with the interactive 3D instructions for the removal and installation of the rear glass slide/tilt sunroof cover mechanism. It does not replace but enhance the applicable repair instructions. Press the individual point for animation display of the corresponding operations.

3D ANIMATION, GLASS SLIDE/TILT SUNROOF COVER MECHANISM (STEPS 11 TO 16 AND 17 TO 22) .

Necessary preliminary tasks:

Remove COMPLETE GLASS SLIDE/TILT SUNROOF .
Remove FRONT WATER CHANNEL .
Remove REAR WATER CHANNEL .
Remove motor for glass slide/tilt sunroof operation . See 67 61 005 REMOVING AND INSTALLING/RENEWING DRIVE WITH GEARBOX (FRONT) FOR ACTUATING SLIDE/TILT SUNROOF or 67 61 007 REMOVING AND INSTALLING/REPLACING DRIVE WITH GEAR (REAR) FOR ACTUATING SLIDE/TILT SUNROOF (REAR) .
Remove only E91: rear cross member