Adjusting glass slide/tilt sunroof unit
WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.
If the glass slide/tilt sunroof is outside the adjustment tolerances, adjust as follows:
NOTE:
If both glass slide/tilt sunroof panels are outside of the tolerance, the front glass slide/tilt sunroof panel must be adjusted first.
Carry out the following step on one side first and then the other (first left, then right or vice versa):
- Loosely screw in the Torx screws for the FRONT or REAR glass slide/tilt sunroof panel on the left / right so that the glass roof insert can just be shifted.
- Shift the glass slide/tilt sunroof panel until the ideal position is reached.
- Tighten down all bolts.
- Tightening torque 54 12 01AZ .
- Repeat operations on other side.
- INITIALIZE glass slide/tilt sunroof.