24 31 010 Replacing torque converter shaft seal (GA6HP26Z)

WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

Necessary preliminary tasks

Remove AUTOMATIC TRANSMISSION .

IMPORTANT: After completion of work, check TRANSMISSION OIL LEVEL .
Use only approved transmission oil.
Failure to comply with this instruction will result in serious damage to the transmission.
See AUTOMATIC TRANSMISSION -- OPERATING FLUIDS .

Secure transmission with special tool 24 0 200 on assembly stand 00 1 450.

Remove TORQUE CONVERTER .

Fig 1: Securing Transmission Using Special Tool (24 0 200)

Courtesy of BMW OF NORTH AMERICA, INC.

Attach special tool 24 2 353 to input shaft (1).

Fig 2: Connecting Special Tool (24 2 353) To Input Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in special tool 24 2 351 until it is firmly connected with radial shaft seal.

Screw in special tool 24 2 352 to remove radial shaft seal.

Fig 3: Removing Radial Shaft Seal Using Special Tool (24 2 351 And 24 2 352)

Courtesy of BMW OF NORTH AMERICA, INC.

Oil sealing lip on shaft seal.

Drive in radial shaft seal (1) with special tool 24 2 360 as far as it will go.

Fig 4: Installing Radial Shaft Seal Using Special Tool (24 2 400)

Courtesy of BMW OF NORTH AMERICA, INC.