65 50... Replacing hinges for rear monitor (older version)

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Do not damage or scratch display.

Necessary preliminary tasks:

Remove REAR CABIN MONITOR

Release screws (1).

Tightening torque 65 50 1AZ .

Remove cover (3) from rear cabin monitor (4), unclipping plug (2) and feed out cable.

Installation:

Make sure cover (3) is correctly seated on rear cabin monitor (4).

Fig 1: Identifying Rear Cabin Cover, Monitor, Plug And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws (2).

Tightening torque 65 50 2AZ .

Remove friction hinges (1) from rear cabin monitor (3).

Installation:

Observe gap dimension adjustment when screwing friction hinges (2) to rear cabin monitor (3) on left and right.

Gap dimensions:

0.9 mm
1.5 mm

Fig 2: Identifying Adjustment Gap Dimension

Courtesy of BMW OF NORTH AMERICA, INC.