65 50 025 Removing and installing/replacing video switch

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

IMPORTANT: Comply with instructions on HANDLING OPTICAL FIBRES .

Necessary preliminary tasks:

Disconnect BATTERY NEGATIVE LEAD .
Remove LUGGAGE COMPARTMENT WHEEL ARCH TRIM on left.

NOTE: Video switch is located on the back of the bracket for the TV module.

Release screws (1) and nuts (2).

Remove TV module (3) including bracket.

Fig 1: Identifying TV Module, Screws And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Unfasten plug connection (2) and disconnect.

Remove video switch (3).

Fig 2: Identifying Plug Connection And Video Switch And Screws

Courtesy of BMW OF NORTH AMERICA, INC.