65 12 320 Removing and installing Headunit (base)
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Risk of damage!
There is a hard disk installed in the headunit.
Carry out mechanical work on the headunit and adjacent components with care.
Avoid subjecting the headunit to vibration/shocks.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
IMPORTANT:
Comply with instructions on HANDLING OPTICAL FIBRES
.
Necessary preliminary tasks:
- Remove RADIO AND IHKA CONTROLS
- Disconnect BATTERY EARTH LEAD .
NOTE:
Picture for example purposes only!
Release screws (1).
Pull head unit (2) forward.
Installation note:
Check head unit (2) is correctly seated on retaining lug at marked points.
Unlock and disconnect all plug connections (2) in the marked area.
Remove headunit (1).
Only for US models with satellite radio:
When replacing the headunit, additional work is required!
- Refer to REMOVING AND INSTALLING/REPLACING SATELLITE TUNER (ONLY FOR US MODELS STARTING AT 09/2009) .
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .
Additionally, load service history for following vehicles:
- F01, F02, F03, F07, F10, F11 with production date from 07/2013