65 12 315 Removing and installing (replacing) HU-H)
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Risk of damage!
There is a hard disk installed in the headunit.
Carry out mechanical work on the headunit and adjacent components with care.
Avoid subjecting the headunit to vibration/shocks.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION)
.
IMPORTANT:
Comply with instructions on HANDLING OPTICAL FIBRES
.
Necessary preliminary work:
- Remove RADIO AND IHKA CONTROLS .
- Disconnect NEGATIVE BATTERY CABLE .
NOTE:
Picture for example purposes only!
Unfasten screws (2).
Pull headunit (3) out of guide.
Installation note:
Make sure headunit (3) is correctly seated in guide lugs (1).
Set the protective nonwoven material (1) aside as shown.
Unlock plug connections.(2) and disconnect.
Remove headunit (3).
Only for US models with satellite radio:
When replacing the headunit, additional work is required!
- Refer to REMOVING AND INSTALLING/REPLACING SATELLITE TUNER (ONLY FOR US MODELS STARTING AT 09/2009) .
Replacement:
Carry out VEHICLE PROGRAMMING AND ENCODING .
Additionally, load service history for the following vehicles: F01, F02, F03, F07, F10, F11 with production date from 07/2013