LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 3147 (Lights - Repair) >> Headlight Adjustment >> 63 10 004 Adjusting headlights

63 10 004 Adjusting headlights

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Comply with TEST PREREQUISITES  for headlight adjustment.

IMPORTANT: Do not damage adjusting screws when adjusting headlights.

Remove cover (1) and turn sealing cap (2) in direction of arrow and remove.

Fig 1: Turning Sealing Cap
G06886077Courtesy of BMW OF NORTH AMERICA, INC.

Carry out headlight adjustment at adjusting screws below openings (1) and (2).

  1. Adjusting screw primarily for vertical adjustment
  2. Adjusting screw primarily for lateral adjustment
    Fig 2: Adjusting Screws For Headlight Vertical And Lateral Adjustment
    G06886078Courtesy of BMW OF NORTH AMERICA, INC.

Attention: for height adjustment of LED headlights: 

If necessary, required height adjustment may only be carried out through height adjustment of LED headlights (turn adjusting screw (1) counter-clockwise)! 

  1. LED headlight adjusted too low: 

    Adjust LED headlight higher to correct dimension at adjusting screw (1) (turn adjusting screw (1) counter-clockwise).

  2. LED headlight adjusted too high: 

    Adjust LED headlight at adjusting screw (1) too low (turn adjusting screw (1) clockwise). Only afterwards adjust LED headlight higher to correct dimension at adjusting screw (1) (turn adjusting screw (1) counter-clockwise).

    After headlight adjustment: 

    Perform reference run. To do so, switch the LED headlight off and on. Check again headlight adjustment.