LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 3147 (Lights - Repair) >> Front Lights >> 63 11 550 Removing and installing/replacing headlight driver module

63 11 550 Removing and installing/replacing headlight driver module

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Version with xenon lighting system: Danger to life due to high voltage! Therefore disconnect all components from voltage supply before removal.

Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified personnel.

IMPORTANT:

Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks: 

Release screws (1) on headlight (2).

Tightening torque 63 12 3AZ .

Remove headlight driver module (3) in direction of arrow.

Fig 1: Removing Headlight Driver Module
G06886088Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (1) and disconnect in direction of arrow from headlight driver module (2).

Fig 2: Disconnecting Headlight Driver Module
G06886089Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Ensure gasket (1) is fitted correctly during installation.

Gasket (1) must not be damaged and must be installed free from grease.

Latch mechanisms (2) must not be damaged or missing.

Fig 3: Identifying Latch Mechanisms And Gasket
G10064391Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Teach in headlight driver module (1) via vehicle diagnosis.

scientia non olet · About LEMON Manuals