72 11 070 Removing and installing/replacing front lower belt fitting (belt tensioner), driver's seat
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove FRONT SEAT, DRIVER'S SIDE .
Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use
UNLOCK AND DISCONNECT plug connections (1).
Release screw (1).
Installation note:
Replace screw (1).
Tightening torque 72 11 3AZ .
Remove seat belt tensioner.
Installation note:
Belt tensioner is coded against incorrect installation.