2.1 Straightening The Wheel Arch (Rear Side Panel)
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Vehicles in which the wheel arch is not welded but bonded and bordered can be straightened.
This is possible in the following situations:
- Rear side panel (wheel arch) is not torn in the area of the bonding. Welding in this area is not permissible.
- The outer skin has not become separated from the outer wheel arch section.
In general, the following applies:
When performing straightening work on the wheel arch, apply sealant to the inside. After straightening, the area must be primed and resealed with sealant D1.