27 10 050 Replacing output flange for output to the front axle (ATC 350)
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2014 BMW Alpina B7L xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Do not move vehicle with driving power once propeller shaft has been removed.
Replace output flange only together with a new radial shaft seal.
After completion of work, check GEARBOX OIL LEVEL .
Use only the APPROVED OIL .
Failure to comply with this requirement will result in serious damage to the transfer case!
Replace output flange only together with a new radial shaft seal.
After completion of work, check GEARBOX OIL LEVEL .
Use only the APPROVED OIL .
Failure to comply with this requirement will result in serious damage to the transfer case!
Operation is identical to REPLACING RADIAL SHAFT SEAL FOR OUTPUT TO THE FRONT AXLE .