37 13... Notes on fitting a new pipe or a screw connection

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Do not kink, twist or crush lines.

Do not disassemble screw connection!

Fitting new screw connection

Insert complete new screw connection consisting of toothed ring (1), banjo bolt (2) and assembly plug (3) into air spring/pipe connection of air supply unit.

Tightening torque 37 12 3AZ.

Remove assembly plug (3).

Fig 1: Identifying Toothed Ring, Banjo Bolt And Assembly Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Slide new pipe (1) into banjo bolt (2) up to marking.

Check installation position of pipe (1) by pulling back slightly.

NOTE: The toothed ring (3) has engaged correctly when the pipe (1) cannot be pulled back.

Fig 2: Identifying Pipe, Toothed Ring And Banjo Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Fitting new pipes

IMPORTANT: To avoid leaks in the air spring system, it is essential to avoid scratches on pipes in particular in the connection area!