16 13 522 Removing and installing/replacing temperature sensor for Natural Vacuum Leak Detection (NVLD)

WARNING: This page does not describe the selected car, but rather 24 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750i, and 2015 BMW 750Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Only unclip seat bench (1) as shown on the left and right and fold up in direction of arrow.

Secure seat bench on front seat (2).

Fig 1: Securing Seat Bench On Front Seat

Courtesy of BMW OF NORTH AMERICA, INC.

Fold both floor trim panels (1) to the side.

Unscrew nuts (2).

Remove cover for service opening (3).

Fig 2: Identifying Floor Trim Panels, Service Opening Cover And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Carefully press tab (2) in direction of arrow.

Feed out temperature sensor (3) towards top.

Installation note:

Make sure latch mechanism of temperature sensor on flange cover is correct.

Fig 3: Pressing Tab

Courtesy of BMW OF NORTH AMERICA, INC.