LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 3137 (Fuel Supply System - Repair) >> Drawing Off Of Fuel, System Cleaning >> 16 00 510 Conducting leak test on fuel tank and tank venting system

16 00 510 Conducting leak test on fuel tank and tank venting system

WARNING: This page does not describe the selected car, but rather 24 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750i, and 2015 BMW 750Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: On vehicles with tank leak diagnosis modules (DMTL), do not work with external pressurisation as the tank ventilation system will leak under this condition.
On account of emerging fuel vapours, carry out all work in well ventilated rooms. Or use a suitable extractor system.
Observe country-specific accident prevention and occupational safety regulations.
NOTE: The following procedure is only applicable to vehicles with  the tank leak diagnosis module (DMTL).
For vehicles without  tank leak diagnosis module:
Pressurise FUEL TANK AND TANK VENTING SYSTEM .
During the leak test with a leak detector, be sure to follow the operating instructions of the equipment manufacturer.
NOTE: Select "Tank leak diagnosis module (DMTL)" on Diagnosis and Information System (DIS).
  • The leak diagnosis pump pressurises the fuel tank and tank ventilation system for 30 sec.
  • If pressure is needed for longer than 30 sec., press "Activate" button again after 30 sec.

The leak test can be carried out with a leak detector.

Possible causes may be: