16 00 005 Draining and filling fuel tank

WARNING: This page does not describe the selected car, but rather 24 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750i, and 2015 BMW 750Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

16 1 080

IMPORTANT: Observe country-specific safety regulations.
Ensure adequate ventilation in the place of work!
Connect the exhaust and extraction systems to the exhaust tailpipe.
The electric fuel pump must not operate without fuel! After completing repairs but before starting the engine for the first time, fill the fuel tank with min. 5 l fuel through the fuel filler pipe.
Do not damage non-return flap when pulling out extraction hose.

Diesel vehicles

Before starting the engine for the first time, if the tank has been run dry or drawn off, fill with diesel fuel and turn on ignition for approx. 1 minute. The fuel circuit is thus filled and vented, which results in the engine firing more quickly.

Drawing off fuel

Start engine and allow to run.

The electric fuel pump runs.

In this way, the fuel is repumped through the suction jet pump from the left to the right side of the fuel tank.

NOTE: Fuel can be drawn out of left and right sides of tank through filler neck, leaving only a small residue. The residual amount is drawn off via the service opening.

Insert special tool 16 1 080 into fuel filler neck.

Special tool 16 1 080 has two different diameters for petrol/gasoline and diesel vehicles!

Slide extraction hose of extractor unit through special tool 16 1 080 into the fuel filler pipe, turning in the process if necessary.

Insertion length approx. 170 cm.

Draw off fuel with suction unit as far as possible.

Follow drawing off of fuel on fuel gauge in instrument cluster.

Fig 1: Inserting Special Tool (16 1 080) Into Fuel Filler Neck

Courtesy of BMW OF NORTH AMERICA, INC.

Drawing off residual fuel quantity

Drawing off residual fuel amount is not included in the time value of this operation.

IMPORTANT: Ensure car interior is adequately ventilated.
Catch dripping fuel in a suitable container.

Remove flange cover . See 16 14 200 REMOVING AND INSTALLING/REPLACING FLANGE COVER (OUTER FUEL FILTER) or 16 14 200 REMOVING AND INSTALLING/REPLACING FLANGE COVER .

Draw off residual fuel quantity through service openings.

Fuel filling

Insert special tool 16 1 080 into fuel filler neck.

Special tool 16 1 080 has two different diameters for petrol/gasoline and diesel vehicles!

Slide extraction hose of extractor unit approx. 40 cm into fuel filler pipe.

Fill fuel from suction extractor unit.

Fig 2: Inserting Special Tool (16 1 080) Into Fuel Filler Neck

Courtesy of BMW OF NORTH AMERICA, INC.

Extracting fuel after a defect in the suction jet pump or fuel pump

Draw off right half of tank completely through fuel filler pipe.

Remove flange cover . See 16 14 200 REMOVING AND INSTALLING/REPLACING FLANGE COVER (OUTER FUEL FILTER) or 16 14 200 REMOVING AND INSTALLING/REPLACING FLANGE COVER .

Insert extraction hose through service opening in tank, fuel (also residual quantity) can be drawn off.