67 11 555 Removing and installing/replacing actuator drive for fuel filler flap

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove RIGHT LUGGAGE COMPARTMENT WHEEL ARCH PANEL .

Unclip cable guide (1) and plastic clip (2).

Partially remove insulating mat (3) in working area.

Fig 1: Identifying Insulating Mat, Cable Guide And Plastic Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken screws (1)

Carefully feed actuator drive (3) out of guides (4).

Unlock plug connection (5) and disconnect.

IMPORTANT: Risk of damage:
To prevent damaging locking pin guide (2), do not tilt actuator drive (3).

Installation note:

Make sure actuator drive for fuel filler flap is correctly adjusted. It must be possible to lock or unlock the fuel filler flap completely.

Fig 2: Identifying Actuator Drive, Guide, Plug Connection, Locking Pin Guide And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Unhook emergency operation tensioning strap (2) from clamp (1) and remove from locking pin (3) of actuator drive (4).

Fig 3: Identifying Actuator Drive, Tensioning Strap, Clamp And Locking Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Turn sleeve (1) with a suitable tool (e.g. pointed pliers) approx. 45° in direction of arrow and pull out of receptacle (2).

Fig 4: Pulling Out Receptacle Using Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure sleeve (1) is correctly seated on locking pin for fuel filler flap (2).

Fig 5: Identifying Fuel Filler Flap And Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.