18 12 046 Replacing front silencer (N63)
WARNING: This page does not describe the selected car, but rather 24 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750i, and 2015 BMW 750Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 31 2 220
WARNING:
Risk of burns!
Only perform these tasks after exhaust system has cooled down.
Only perform these tasks after exhaust system has cooled down.
Necessary preliminary work
- Remove rear UNDERBODY PROTECTION .
Support front silencer with special tool 31 2 220 and a suitable universal lifter.
NOTE:
If the separation point is not marked by a punch mark in the pipe, determine the separation point by means of the pipe length on the new front silencer.
Carry over separation point to faulty front silencer and mark.
Secure front silencer against falling out.
Cut through exhaust pipes at marked point with a suitable tool.
Carry over separation point to faulty front silencer and mark.
Secure front silencer against falling out.
Cut through exhaust pipes at marked point with a suitable tool.
Picture shows the left side, the procedure for the right side is identical.
Slacken nut (1).
Tightening torque 18 31 1AZ .
Replace self-locking nuts.
Replace seals.
Unscrew nuts (1).
Tightening torque 18 20 1AZ .
Installation note:
Install front silencer, adjust, and connect with clamps.
Centre clamps and tighten down.
Tightening torque 18 31 4AZ .
NOTE:
Check exhaust system for leaks.