22 32 001 Replacing rubber mount for transmission mounting (ATC 350)
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750i, and 2015 BMW 750Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
Necessary preliminary tasks
- Remove complete EXHAUST SYSTEM .
- Remove TRANSMISSION CROSS MEMBER.
For better illustration: Front propeller shaft is removed.
IMPORTANT:
For : F01, F07, F10, F11, F12, F13 - N57 and N55 a gearbox mount is located on the left side of the transmission below the front propeller shaft.
Undo bolts (1) for gearbox mount.
Undo bolts (1) for gearbox mount.
Tightening torque 22 32 10AZ .
Necessary preliminary tasks
Lower transmission with hydraulic lifting equipment.
Mount special tools 22 1 042 / 22 1 041 on transfer box.
Pull out rubber mount with thrust plate 22 1 043 by means of spindle33 4 460 and nut22 1 017.
Installation note:
Pay attention to installation position of rubber mount (1).
Bolt special tool 22 1 044 to transfer box.
Insert special tool 22 1 046 with bolt into recesses of rubber mount.
Draw in rubber mount with special tool 33 4 460.
Installation note:
Auxiliary installation material - low-surface tension water.
Do not coat rubber mount with grease.