51 71... Removing and installing/replacing (front) left or right suspension cross-brace
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 120
IMPORTANT:
Driving without the suspension cross-brace is not permitted. (risk of damage to the body).
Tighten screw on suspension cross-brace to torque. Then tighten to angle of rotation, special tool 00 9 120.
Tighten screw on suspension cross-brace to torque. Then tighten to angle of rotation, special tool 00 9 120.
Release screws (1).
Tightening torque 51 61 1AZ AND 2AZ .
Remove suspension cross-brace (2).
Installation:
Make sure suspension cross-brace (2) is in correct installation position. Screw with washer is fitted at connection, front top.