51 71 447 Removing and installing or replacing trim panel for cover on left or right side member

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove UNDERBODY PANELLING .

NOTE: Open doors.

Release screws (1).

Unclip the trim panel for the cover on the side member in direction of arrow and remove.

Installation note:

Make sure cover is correctly seated on side member.

Fig 1: Removing Side Member Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Protective film on rear door post for preventing paint abrasion between side frame and trim for cover on side member must not be missing or damaged.

Foil strip is slightly bent in area (1) and must not project over edge (2).

Fig 2: Identifying Project Over Edge And Bent Area

Courtesy of BMW OF NORTH AMERICA, INC.