36 10... General notes on wheel and tires (BMW ALPINA B7)

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Pay attention to released wheel and tire combinations for BMW ALPINA.
The valve for checking the tire inflation pressure is located under the hub cap.

Removing the hub cap

Press on emblem in area (1) and turn in direction of arrow.

Fig 1: Turning Emblem

G04778883

Courtesy of BMW OF NORTH AMERICA, INC.

Open lock with key (1) and remove hub cap (2).

Fig 2: Identifying Hub Cap And Lock With Key

G04778884

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure that there are 10 friction film pieces (see arrows) on the hub cap.

When replacing the hub caps, the supplied friction film pieces must also be attached.

Fig 3: Locating Friction Film Pieces On Hub Cap

G06890106

Courtesy of BMW OF NORTH AMERICA, INC.

Note on valve insert

IMPORTANT: In the event of repair, only valve insert (1) may be replaced!
The screw valve (2) must not be removed from the wheel rim!

Fig 4: Identifying Valve Insert And Screw Valve

G04778886

Courtesy of BMW OF NORTH AMERICA, INC.