Filling/inflating tire
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Remove all fitting aids.
IMPORTANT:
Possibilities for safely mounting the wheel or incorporation in inflation apparatus should be utilized!
Observe instructions/conditions of trade association.
Observe national regulations!
Observe instructions/conditions of trade association.
Observe national regulations!
Inflate with air (without valve insert).
- Increase pressure up to 3.3 bar in stages (fitting pressure).
- If the tire bead does not slip fully past the rim edge all round, do not under any circumstance increase the pressure.
- If necessary, release air and force off tire bead again.
- Coat rim flange and tire again with tire mounting paste.
- Inflate tire again up to 3.3 bar.
- When tire beads are resting perfectly on rim shoulders, increase tire pressure to maximum 4.0 bar (settling pressure) to "settle" the tire.
Screw in valve insert and correct the tire pressure.
Observe notes on initialization of the RUN FLAT INDICATOR (RPA) or RDC (USA=TPM).
IMPORTANT:
Advise the customer to avoid heavy acceleration and heavy breaking in the initial period.
The assembly paste can cause the tire to turn on the wheel rim and give rise to imbalance.
The assembly paste can cause the tire to turn on the wheel rim and give rise to imbalance.