64 11 823 Replacing actuator drive for right rear cabin air blending flap

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove INSTRUMENT PANEL TRIM .

Position of actuator drive:

OVERVIEW OF ACTUATOR DRIVES ON HEATER/AIR CONDITIONER

Release screws (1).

Installation note:

Replace screws.

Take off holder (2).

Fig 1: Identifying Holder And Screws

G06886222

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip connector piece (1) and slide downwards.

Installation note:

Latching of connector piece (1) must be felt.

Fig 2: Removing Connector Piece

G06886223

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove air vent duct (2).

Installation note:

Ensure cable routing along air vent duct (2) is correct

Fig 3: Identifying Right Footwell Air Outlet Duct And Screws

G06886224

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Remove actuator drive (2) and unlock and disconnect associated plug connection.

Fig 4: Identifying Actuator Drive And Screws

G06886229

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Servomotors must be re-addressed in the event of replacement!

Addressing can only be carried out with the BMW diagnosis system.

Service functions:

Body
Heating and A/C function
Flap motors
Re-address flap motors