61 35 245 Removing and installing (replacing) Smart Opener bottom sensor line (non-contact rear lid opening)

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD PROTECTION) .

Necessary preliminary work

Remove COVER ON REAR BUMPER PANEL .

Release latch mechanisms (1) and remove control unit (2) in direction of arrow.

Fig 1: Removing Control Unit By Releasing Latch Mechanisms

G08509852

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock associated plug connection (1) on control unit (2) and disconnect.

Feed out connecting line from cable clips (3).

Fig 2: Identifying Control Unit, Cable Clips And Plug Connection

G08509853

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage, do not kink sensor line!

Dismantling sequence:

Detach sensor line (1) from holder (2) to the top
Detach sensor cable (1) from holder (2) to the right

Installation note:

Make sure plug connection and sensor line (1) are correctly fitted.

Fig 3: Detaching Sensor Line And Cable From Holder

G08509854

Courtesy of BMW OF NORTH AMERICA, INC.

Make sure connecting line is correctly laid.

Brackets must not be damaged.