61 35 240 Removing and installing (replacing) Smart Opener control unit (non-contact rear lid opening)

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD PROTECTION) .

Necessary preliminary work

Remove COVER ON REAR BUMPER PANEL .

Release latch mechanisms (1) and remove control unit (2) in direction of arrow.

Fig 1: Removing Control Unit By Releasing Latch Mechanisms

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) from control unit (2) and detach.

Feed out connecting lines from holder (3).

Installation note:

Make sure plug connections (1) and control unit (2) are correctly fitted.

Make sure connecting lines are correctly routed at holder (3).

Fig 2: Identifying Control Unit, Cable Clips And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.