33 17 004 Replacing all rubber mounts for rear axle final drive mounting at front

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

IMPORTANT:

To ensure that the rear axle rubber mounts are securely seated in the rear axle support, observe a waiting period of 2 hours after pressing in the rubber mounts or before driving the vehicle for the first time.

Failure to comply with this requirement may cause the rubber mounts to drift in the rear axle support!

Necessary preliminary tasks:

Remove REAR AXLE FINAL DRIVE .

Pull out rubber mount with special tools 33 0 026 , 33 0 027 , 33 0 022 and 33 0 021 .

NOTE: Use ratchet ring spanner 33 5 105.

Fig 1: Pulling Out Rubber Mount Using Special Tools (33 0 026, 33 0 027, 33 0 022 And 33 0 021)

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Coat bearing bushing in rear axle carrier and rubber mount (1) with Circo Light.

Align rubber mount (1) by means of notch (2).

Protrusion (3) points to rear final drive unit.

Fig 2: Identifying Rubber Mount, Notch And Protrusion Points

Courtesy of BMW OF NORTH AMERICA, INC.

Insert rubber mount (1) in special tool 33 0 025 .

Pull on rubber mount (1) with special tools 33 0 026 , 33 0 027 , 33 0 024 and 33 0 023 as far as it will go.

NOTE: Use ratchet ring spanner 33 5 105.

Fig 3: Pulling On Rubber Mount Using Special Tools (33 0 026, 33 0 027, 33 0 024 And 33 0 023)

Courtesy of BMW OF NORTH AMERICA, INC.