33 32 180 Removing and installing/replacing left or right toe arm
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If the toe arm is detached from the rear axle support, it will be necessary to carry out a wheel alignment procedure after assembly. See ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION
or ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD
.
Necessary preliminary work:
- Remove REAR WHEEL .
Release nut (1) and remove heat shield (2).
Tightening torque 33 32 10AZ.
Installation note:
Replace self-locking nut.
Remove cable holder (1) from toe arm, if applicable.
Installation note:
Replace faulty cable clips.
Release screw (1).
Tightening torque 33 32 6AZ.
Pull out bolt (1) and remove toe link (2).
Installation note:
Tighten down screw connection in NORMAL POSITION .
Slacken nut (1).
Tightening torque 33 32 7AZ
Remove toe link (2) from wheel carrier.
Installation note:
Insert toe link (2) first in wheel carrier.
Keep toe link to wheel carrier connection clean and free from oil and grease.
Replace nut.
After installation:
- Carry out wheel alignment procedure. See ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD .