33 32 051 Removing and installing/replacing left or right anti-roll bar link/integral link

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If the integral link is detached from the swinging arm, it is necessary after installation to carry out a chassis / wheel alignment check.

Necessary preliminary work:

Remove REAR WHEEL .

Release nut (1) and remove screw.

Tightening torque 33 32 4AZ.

Release screw (2) and remove integral link (3).

Tightening torque 33 32 5AZ.

Installation note:

Replace screw and nut.

Tighten screw connections in NORMAL POSITION .

Fig 1: Identifying Integral Link, Nut And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Perform chassis / wheel alignment check. See ALIGNMENT CHECK WITH VEHICLE LOAD UP TO DESIGN POSITION or ALIGNMENT CHECK WITH RIDE HEIGHT MEASUREMENT WITHOUT VEHICLE LOAD .