32 41 314 Replacing suction line for power steering (from fluid reservoir to connecting piece)
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2015 BMW Alpina B7L xDrive, 2015 BMW Alpina B7 xDrive, 2015 BMW 750i xDrive, 2015 BMW 750Li xDrive, and 2015 BMW 740Li xDrive. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
DANGER OF POISONING if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off line connections with seal plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable expansion tank.
Necessary preliminary work:
- Draw off and dispose of hydraulic fluid from oil reservoir
- Remove OIL RESERVOIR from body.
- Remove RAW-AIR SUPPLY ON LEFT .
Unfasten hose clamp (1).
Disconnect intake pipe (2) from oil reservoir.
Installation note:
Marks on oil reservoir and intake pipe must match up.
Replace hose clamp.
Unfasten hose clamp (1).
Remove intake pipe (2).
Installation note:
Replace hose clamp.
Make sure intake pipe is laid without tension and with sufficient distance to adjoining components.
After installation:
- Fill and bleed hydraulic system. See BLEEDING POWER STEERING UNIT or BLEEDING POWER STEERING (VERSION WITH DYNAMIC DRIVE) .
- Check line connections for leak tightness