51 45 184 Removing and installing (replacing) trim panel for pedal mechanism (US only)

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Read and comply with SAFETY REGULATIONS for handling airbag modules and pyrotechnical belt tensioners.

IMPORTANT: Operations on pyrotechnical devices may only be carried out by authorized experts.
Improper, unauthorized operations may result in serious dangers.
Unauthorized persons are strictly prohibited from performing any operations on this system.

Detach the BATTERY CABLE NEGATIVE TERMINAL .

Release screws (1).

Installation note:

Replace screws.

Tightening torque 51 45 4AZ .

Unscrew screw (3) and remove carpet trim (4) by pulling forward.

Unclip panel for pedal assembly (2) and lower slightly.

Disconnect plug connections behind.

Fig 1: Identifying Pedal Assembly, Carpet Trim And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove panel for pedal assembly (2)

Replacement

Remove FOOTWELL LIGHT .
Remove the SPEAKER OF THE HANDSFREE SYSTEM .
Remove AIRBAG MODULE .