54 37 028 Replacing soft top compartment lid gasket

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2013 BMW 328i, 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 335i, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: To prevent water ingress, removed gaskets may not be reused.

Open rear end module.

Fig 1: Opening Rear End Module

G06180203

Courtesy of BMW OF NORTH AMERICA, INC.

Release sheet screw (1) and thin sheet screw (2) on left and right.

Installation note:

Make sure screws are installed in correct positions.

Fig 2: Identifying Sheet Screw And Thin Sheet Screw

G06180204

Courtesy of BMW OF NORTH AMERICA, INC.

Completely retract retractable hardtop and open rear cover.

Pull off gasket (1) from left to right.

Installation note:

Do not stretch, kink, or crush gasket (1)!

Coat gasket (1) with soapy water.

Perform installation from left to right (check bolting points).

Fig 3: Pulling Off Seal

G06180205

Courtesy of BMW OF NORTH AMERICA, INC.