22 11 001 Replacing right engine mount AWD (N54)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW 335xi, 2010 BMW 335i, 2009 BMW 335xi, 2009 BMW 335i, and 2008 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
Secure engine in installation position. See 11 00 670 SECURING ENGINE IN INSTALLATION POSITION (N54) .
Remove underbody protection. See 5147490 REMOVING AND INSTALLING/REPLACING FRONT UNDERBODY PROTECTION (AWD) .
Remove reinforcement plate.
Release screws (1) and remove engine mount (2).
Tightening torque 22 11 1AZ .
Installation:
Rubber section (1) of engine mount must point to middle of vehicle.
Engine mount designations:
Right engine mount
- With heat cap.