Adjusting glass slide/tilt sunroof unit

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

If the glass slide/tilt sunroof is outside the adjustment tolerances, adjust as follows:

NOTE: If both glass slide/tilt sunroof covers are outside of the tolerance, the front glass slide/tilt sunroof cover must be adjusted first.

Carry out the following step on one side first and then the other (first left, then right or vice versa):

Loosely screw in the Torx screws for the FRONT or REAR glass slide/tilt sunroof cover on the left/right so that the glass roof insert can just be shifted.
Shift the glass slide/tilt sunroof cover until the ideal position is reached.
Tighten down all bolts.
Tightening torque 54 12 01AZ .
Repeat operations on other side.