2.1 Partially detached bond (rubber-adhesive tape or adhesive tape-paint)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
- Up to 120 mm for retouching without auxiliary resources
- Up to 200 mm repaired with pressing-on tools on straight surfaces
- Cleaning damaged areas:
- Degrease bonded area with adhesive cleaner (refer to BMW Parts Service) and remove other residues.
NOTE: Use necessary cotton- or fluff-free paper towel once only.
When using solvent: expose repair area to air for at least 2 minutes. - Applying adhesive:
- With a fine nozzle, apply a wafer-thin bead to adhesive tape.
NOTE: Use contact adhesive (e.g. Terokal 2444)CAUTION: Avoid contact to skin!
Do not apply adhesive to visible painted surfaces. - Pressing on rubber seal:
- Press down seal using contact pressure (forced pressure not necessary) for at least 1 minute.
CAUTION: Load can only be applied to the bond after a period of 2 minutes. This waiting time is absolutely essential.