62 11 280 Removing and installing (replacing) instrument cluster

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .

IMPORTANT: Risk of damage!
Carry out this operation carefully so as to avoid damaging the instrument panel.

Extend steering wheel completely and lower.

Fig 1: Pulling Instrument Cluster

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1). Tightening torque 62 11 1AZ .

Pull instrument cluster (2) forward slightly in direction of arrow.

Disconnect associated plug connection.

If necessary, feed out/unclip associated wiring harness.

Remove instrument cluster (2).

Replacement:

Carry out vehicle programming/coding.

Check values for Condition Based Service (CBS) and correct if necessary.