Necessary preliminary tasks

• Remove PEDAL TRIM .

Press end of pin (1) together with offset pliers and press out pin.

Fig 1: Identifying Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Push in pin (1) fully in direction of arrow.

Fig 2: Pushing In Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Detach retainers (1).

Installation: 

Check retainers, replace if necessary.

Retainers must lie with both legs in the groove and snap audibly into place.

Slide out pin (2).

Installation: 

Lightly grease pin.

Remove over-center helper spring (3).

Fig 3: Identifying Over-Centre Helper Spring, Retainers And Pin

Courtesy of BMW OF NORTH AMERICA, INC.

There are two versions:

• (A) Over-center helper spring
• (B) Reinforced over-center helper spring

Assembly of over-center helper spring:

• Secure black holder (1) to clutch pedal
• Smaller coil spacing of spring (2) points to black holder (1)
• Secure grey holder (3) to bearing block
  Fig 4: Identifying Over-Center Helper Spring And Reinforced Over-Centre Helper Spring

  Courtesy of BMW OF NORTH AMERICA, INC.

Lightly grease holder and spring contact surfaces.

Installation: 

Secure over-center helper spring first with black holder to clutch pedal.

Gently press over-center helper spring together and secure with grey holder to bearing block.

Connect clutch pedal to clutch master cylinder.

When replacing reinforced over-center helper spring:

Fig 5: Identifying Locking Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

Remove locking clamp (1).