37 14 512 Replacing rear ride-height sensor: Notes

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

NOTE: Jointed rod to camber arm holder 37 14 3AZ .

Release nut (1) and disconnect jointed rod (2).

Installation:

Tightening torque 37 14 3AZ .

Disconnect plug connection (3).

Release bolt (4) and remove ride-height sensor with bracket.

Fig 1: Identifying Jointed Rod, Bolt, Nut And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Align bracket to corresponding bore hole (arrow) in rear axle carrier.

Tightening torque 37 14 2AZ .