52 26 311 Removing and installing/replacing lock for left or right rear seat backrest

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Gently slide lock trim (1) on side edge of backrest downwards and unclip to one side.

Gently slide lock trim (1) on rear side towards middle and unclip.

Remove lock trim (1).

Fig 1: Removing Lock Trim

G05507192

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retaining lugs on trim must not be damaged.

Fig 2: Locating Retaining Lugs On Trim

G05507193

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!

Insert plastic wedge from outside between trim (1) and lock.

Carefully lever outer side of trim (1) with plastic wedge upwards out of catch.

Lever inner side of trim (1) with plastic wedge out of catch.

Remove trim upwards.

Fig 3: Removing Trim

G04792103

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out backrest cover (1) in working area.

Fig 4: Removing Backrest Cover

G04792104

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws and feed lock (1) out of rear seat backrest.

Tightening torque 52 26 07AZ .

Fig 5: Identifying Lock

G04792105

Courtesy of BMW OF NORTH AMERICA, INC.