52 26 199 Removing and installing/replacing rear panel on left rear seat backrest: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Retaining lugs on trim must not be damaged.

Fig 1: Locating Retaining Lugs On Trim

G05507193

Courtesy of BMW OF NORTH AMERICA, INC.

Version without ski bag

Lever backrest cover all round out of backrest frame.

Fig 2: Removing Backrest Cover From Backrest Frame (Version Without Ski Bag)

G04727365

Courtesy of BMW OF NORTH AMERICA, INC.

Version with ski bag

Lever backrest cover all round out of backrest frame.

Fig 3: Removing Backrest Cover From Backrest Frame (Version With Ski Bag)

G04727374

Courtesy of BMW OF NORTH AMERICA, INC.

Detach rear panel (2) with flat scraper (1) from rear seat backrest.

Installation:

Comply with instructions issued by manufacturer of universal spray adhesive.

Apply universal spray adhesive to rear panel and rear seat backrest.

Fit and align rear panel within the air drying time (see manufacturer's instructions).

Observe and adhere to curing time to prevent rear panels from slipping.

Fig 4: Removing Rear Panel Using Flat Scraper

G04727318

Courtesy of BMW OF NORTH AMERICA, INC.