11 14 085 Removing and installing top right timing case cover (N62 / N62TU)

(Cylinder Bank 1 To 4) 

Necessary Preliminary Tasks: 

• Remove right cylinder head cover. Refer to 11 12 006 REMOVING AND INSTALLING/SEALING RIGHT CYLINDER HEAD COVER (N62/N62TU) .
• Remove vacuum pump. Refer to 11 66 000 REMOVING AND INSTALLING/REPLACING VACUUM PUMP (N62/N62TU) .
• Remove both solenoid valves on right side. Refer to 11 36 720 REMOVING AND INSTALLING/REPLACING BOTH SOLENOID VALVES ON RIGHT SIDE (N62/N62TU) .

Remove cable from holder.

Fig 1: View Of Cable In Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1 and 2).

Remove timing case cover (3).

Fig 2: Locating Timing Case Cover Retaining Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Free sealing face (2) on timing case cover (3) of seal debris and clean.

Fig 3: Identifying Free Sealing Face On Timing Case Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Check adapter sleeves (1) for damage and correct installation position; replace if necessary.

Free sealing face (2) of seal debris and clean.

Fig 4: View Of Adapter Sleeves

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Replace gasket (1) and check for correct installation position.

Fig 5: Identifying Timing Case Cover Gasket

Courtesy of BMW OF NORTH AMERICA, INC.