21 51 500 Removing and installing or replacing clutch release bearing/lever: Notes

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: (transmission removed)

New version (except M models)

Release bearing and release lever have been combined to form a single release module.

If possible, do not disassemble the release module. Otherwise, there is a risk of the release module being incorrectly reassembled.

Installation:

Make sure that the correct cam (1) of the release bearing is on the sliding surface (2) of the release lever.

NOTE: Do not grease sliding surfaces (2).

Fig 1: Identifying Cam On Sliding Surface

Courtesy of BMW OF NORTH AMERICA, INC.

Fig. A: Cam (1) of release bearing (A=12 mm) is on sliding surface of release lever.

This version is for 4 cylinder gasoline engines.

Fig. B: Cam (1) of release bearing (A=7 mm) is on sliding surface of release lever.

This version is for 6 cylinder gasoline and diesel engines.

Fig 2: Identifying Dimensions Of Cams On Release Bearing

Courtesy of BMW OF NORTH AMERICA, INC.

Remove release module (1) from spring wire clip.

Remove release module.

NOTE: Illustration similar.

Fig 3: Removing Release Module From Spring Wire Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check spring wire clip (5) and ball pin (6) for damage and replace if necessary.

NOTE: Illustration similar.

Fig 4: Identifying Spring Wire Clip And Ball Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Previous version

Detach release bearing (1).