51 47 490 Removing and installing/replacing front underbody protection: Notes

WARNING: This page is about a different car, the 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 328i, and 2009 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Description is shown on the E87 by way of example. There may be differences in detail in the case of other models.

Release screws (1).

Pull underbody protection (2) forward under bumper trim (3).

Installation:

Centre underbody protection (2) and tighten down screws (1).

Fig 1: Pulling Underbody Protection

Courtesy of BMW OF NORTH AMERICA, INC.