24 00 050 Installing exchange transmission (GA6HP19Z) AWD
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
Drain automatic transmission fluid at oil drain plug.
Tightening torque: 24 11 6AZ .
Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations
IMPORTANT:
- Before installing replacement transmission, always flush transmission fluid cooler together with lines.
- After completion of work, check transmission oil level.
Replacement transmission is supplied filled with transmission fluid.
Use only the approved transmission fluid.
Failure to comply with this instruction will result in serious damage to the transmission.
Necessary preliminary work:
- Remove automatic transmission
- Remove TRANSFER CASE .
- Modify holder
Convert transportation retainer.
Convert all cable clips.
Convert all seal plugs.
Convert protective cap on output shaft.
IMPORTANT:
After removing transportation retainer, secure torque converter against slipping out.
Transmission identification:
- refer to BMW Parts Department.
- on type plate