Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Remove front entrance cover strip (inside). See 51 47 000 Removing and installing/replacing front (inside) left or right entrance cover strip .
Remove TRIM PANEL FOR PEDAL ASSEMBLY .

Detach mucket (1) in area of side trim panel (2).

Unscrew bolt (3).

Remove hood/bonnet release lever (4) from side trim panel (2).

Fig 1: Disconnecting Mucket In Area Of Side Trim Panel

G04752760

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Unclip side trim panel (4) in each case in direction of arrow at retaining points (2 and 3).

If necessary, disconnect associated plug connection and remove side trim panel (4).

Fig 2: Removing Side Trim Panel

G04752761

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clips (1) remaining in bore.

If necessary, replace faulty clips (1).

Position side trim panel (2) preinstalled with clips (1) on associated bores and clip into place.

Fig 3: Identifying Side Trim Panel Clips

G04752762

Courtesy of BMW OF NORTH AMERICA, INC.