Necessary preliminary tasks

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Move both front seats forwards

IMPORTANT: Grip behind trim (1) from below and release catch (2) (risk of damage).

Pull trim (2) towards rear and release from catches (3).

Fig 1: Releasing Catch

G04727600

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1 and 3) must not be damaged.

Guides (2) must not be damaged.

If necessary, release REAR COMPARTMENT FRESH-AIR GRILLE in order to install trim correctly.

Fig 2: Identifying Catches And Guides

G04727601

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Open center armrest otherwise spring (1) will be under too much tension.

Disengage spring (1) with screwdriver (2).

Installation:

Make sure spring (1) is correctly seated.

Fig 3: Removing Spring Using Screwdriver

G04752555

Courtesy of BMW OF NORTH AMERICA, INC.

Drive out hinge shafts (1).

NOTE: Hinge shafts (1) are secured on the outside with toothing (3).

Remove spring (2), open center armrest and feed out of storage compartment.

Fig 4: Removing Hinge Shaft And Spring

G04752556

Courtesy of BMW OF NORTH AMERICA, INC.