51 71 481 Removing and installing/replacing tension strut (on rear axle): Notes
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Vehicles must not be driven without tension struts.
Driving without tension struts may damage the vehicle body.
Tension strut screws must be tightened to torque and then tightened down with special tool 00 9 120 .
Driving without tension struts may damage the vehicle body.
Tension strut screws must be tightened to torque and then tightened down with special tool 00 9 120 .
Release screws (1) and remove tension strut (2).
Installation:
Replace screws.
Tightening torque 51 71 3AZ .