51 32 170 Removing and installing/replacing door window glass, front left or right
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 BMW 328xi, 2012 BMW 328i, 2011 BMW 328xi, 2011 BMW 328i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When removing door lock, it is not necessary to remove window cavity cover strips or seals.
Necessary preliminary tasks:
- Open door window to 105 mm.
- Remove SOUND INSULATION IN FRONT DOOR
E87 only:
E84/90 only:
- Remove INNER WINDOW CAVITY SEAL
Door window glass (1) must be opened to dimension (A).
A = approx. 105 mm
IMPORTANT:
Disconnect plug connection (2) from power window motor (3) (risk of trapping).
Lever out catches (4) with screwdriver (5) in direction of arrow.
Installation:
Catch (4) must be correctly clipped into place.
Carry out function check on power window unit and anti-trapping protection.
If necessary, NORMALIZE power window unit.
Installation:
Following parts of window guide (3) must not be damaged or missing:
- Catch
- Bump stop
When removing door lock:
Slide door window glass upwards and secure in door window frame with adhesive tapes or plastic wedge.
When removing door window glass:
Turn door window glass and lift out towards rear/top.